Standard 295-1969

IEEE Standard for Electronics Power Transformers

Working Group Chairman: Dave Ratliff

Phone: 517-546-6330
email:
marelco@htonline.com

Status: Reaffirmed 1993

Scope:

This standard pertains to power transformers and inductors that are used in electronic equipments and supplied by power lines or generators of essentially sine wave or polyphase voltage. Guides to application and test procedures are included. Appendices contain certain precautions, recommended practices and guidelines for typical values. Provision is made for relating the characteristics of transformers to the associated rectifiers and circuits.

Certain pertinent definitions relating to transformers and transformer applications, which have not been found elsewhere are included with appropriate discussion. Attempts are made to alert the industry and profession to factors that are commonly overlooked.

This standard includes, but is not limited to, the following specific transformers and inductors.

  • Rectifier supply transformers for either high- or low- voltage supplies.
  • Filament and cathode heater transformers.
  • Transformers for alternating current resonant charging circuits.
  • Inductors used in rectifier filters.
  • Autotransformers with fixed taps.

This test procedure is intended to be an evaluation test and not a production inspection or acceptance test.

Thank you for visiting.  This page is hosted through the courtesy of the Grainger Center for Electric Machinery and Electromechanics, Department of Electrical and Computer Engineering, University of Illinois, Urbana, Illinois, USA.  The webmaster can be reached at pels@energy.ece.uiuc.edu.

Contents copyright (c) 1996-2002, IEEE.  All rights reserved.